Jump to content

HOWTO: A guide to making a canvas belt


Recommended Posts

I ended up using 3 rivets to arrach the plastic ammo be;t to the canvas one to keep those pieces laying nice and flat together. Then I used two snaps to connect it to the ab. On my first try the belt was a little below the box on the ab with the five buttons, so I used pliers to carefully take the snaps out of the belt and placed them 1/4 inch higher. Much better!

Link to comment
Share on other sites

  • 6 years later...
  • 2 years later...

Thank you for this I used it to make my belt. small changes. I 'bagged out' the belt after sewing both sides and one end then push plastic supports for the Detonator and the Holster in.  The Detonator bit snapped horizontally but will still give support to the piece, I needed better plastic.

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...