Tall_Trooper[TK] Posted Monday at 07:42 PM Report Share Posted Monday at 07:42 PM Hello There! I would like to customize my detonator (level 2/3). In my opinion the plate is clearly too high. But I'm not so sure what to do. I'll probably have to shorten the clips. But then I would have to drill new holes. Does it make sense to build a new TD? This is roughly what it looks like when I wear it thanks in advance Quote Link to comment Share on other sites More sharing options...
TKSpartan[Staff] Posted Monday at 08:30 PM Report Share Posted Monday at 08:30 PM 54 minutes ago, Tall_Trooper said: Hello There! I would like to customize my detonator (level 2/3). In my opinion the plate is clearly too high. But I'm not so sure what to do. I'll probably have to shorten the clips. But then I would have to drill new holes. Does it make sense to build a new TD? This is roughly what it looks like when I wear it thanks in advance Hi Torben, What comes to my mind as a solution for your TD to actually get the Basic (L2 and L3 accuracy) would be a 3 steps fix. CRL Basic Level : The white control panel raised ribbed pad faces the rear, with the controls/round washer style detail closest to the right end cap. 1- Remove the Buttons plate 2- Trim the Clips (Drill new holes on metal) and rotate the pvc pipe downwards so you don't need to drill new holes on it. 3- Place the Buttons panel on the correct position Some references on how the TD would look when wearing it. 1 Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted Monday at 10:50 PM Report Share Posted Monday at 10:50 PM You could also just re-bend the clips (if the material allows) or even make new clips and use the existing holes, this will also save removing the control plate. The height and length of the clips dictates where the control panel will sit on the wearer. 1 Quote Link to comment Share on other sites More sharing options...
JBar[TK] Posted 9 hours ago Report Share Posted 9 hours ago I had the same problem. I ended up cutting the tips off and drilling two new holes. It didn't take as long as I expected and now the "donut" faces outward instead of upward Before: After: 2 Quote Link to comment Share on other sites More sharing options...
Tall_Trooper[TK] Posted 9 hours ago Author Report Share Posted 9 hours ago Thanks! I try to do my best. 3 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.