TK-21476 requesting ANH Stunt EIB status [ATA] (1080)

**lugalleg[TK]** · August 30

Trimmed the rear left thigh cover strip and filled in with ABS paste

Helmet trap decal just had glare on it.

Smoothed out tears and tried to photograph with minimal glare.

Let me know what else you need

**lugalleg[TK]** · August 30

Both tears go over a bump in the helmet which kind of look like a big bubble.

**Doggydoc[Staff]** · September 3

Hi Lucas, and thank you for your EIB application!

CRL and EIB Application Requirements:

All required photos have been submitted, and on behalf of the entire D.O. staff we are pleased to welcome you to the rank of Expert Infantry. Congratulations! :salute:

You have done a great job on fixing the frown, coverstrip, decal and blaster issues and even gone ahead and corrected several items that will be required for centurion level approval.

Other-Armor Fit/Assembly;

In this area we review observations made by your fellow troopers and the DO team. Some observations may lead to suggestions to improve the overall look of your armor, and please keep in mind that we consider both text (CRL) and pictures (screen caps/reference images) when reviewing submissions.

1. A small touch up is recommended for your vocoder. Could you please remove the pencil guide lines (blue arrows). Although not required for approval, if you would like a more clean look, when you are doing this, you may want to slightly lengthen the stripe marked in yellow on the left side in the photo to make it more symmetrical with the right side.

References

2.Your small button plate could be shortened in length slightly to be more screen accurate.

References

***************************************************

Centurion Requirements:

In this section we prepare you for our highest tier of approval. Because Centurion photos must show more detail than EIB, items pertaining to Level 3 might be seen there and not here and additional photos may be required. We try to point out all that we can from what we are able to clearly see, but the final accuracy is the responsibility of the trooper.

1. The abdominal -kidney armour seam on the left side shows the hinge in the gap. This is a great method to connect the pieces but the hinge and gap should not be showing from the outside.

CRL L3: Ideally there no gap between the abdomen and kidney armor. Abdominal and Kidney Plate align horizontally at top.

A single visible seam line is present

References

2. Your Han snap is sitting a bit too low. It will need to be moved up slightly. This will take a bit of work with ABS paste to fill the hole but looking at your work on the ab plate, you should have no problem with this.