fishgoh0nk Requesting Pre-Approval Review (ANOVOS)

[fishgoh0nk[TK]]

On 6/6/2021 at 3:48 PM, gmrhodes13 said:

Your ab snap is a little low, may get picked up at higher levels

 

Moved the button - it's been there for 2 years and I didn't have the means to move it. Now I do and it wasn't so bad. The ABS paste definitely needs to be applied in layers. One big glob yielded bubbles and dark spot.... which I had to paint. I actually used drywall patch to fill up some of it..

 

A few more hours of dry and sand might have made it completely smooth... but overall I'm happy with it

Edited June 9, 2021 by fishgoh0nk

[gmrhodes13[Staff]]

Nice work, came out great

[fishgoh0nk[TK]]

On 6/6/2021 at 3:48 PM, gmrhodes13 said:

TD screws are a little on the large side, although may not be picked at higher levels

 

Hoping to see you approved very soon, good luck

I'm in! Thanks for all the help!

 

For L2/L3, I updated the thermal detonator with new aluminum strips and smaller screws. How does this look?

 

 

 

New vs Old, glad I ordered extra aluminum, bending them was a PITA

 

My only fear is that the clips are too tall - I went by bondservant's instructions and figured I wanted the TD to sit in the middle of the belt rather than at the top. Is this OK?

 

 

 

 

It's actually sitting a little below the equator, I can always role the TD's J bend upwards for a higher ride?

Edited June 24, 2021 by fishgoh0nk
more pics

[giskard8[Staff]]

Do roll it higher, looks more accurate that way.

 

The setup of your detonator face plate should still be fine.