RS ANH Trooper Shin Trimming

[Zinfer[TK]]

Pretty sure I'm not the first to come across this problem.  I meant to begin drawing out my cut marks for the RS Shins when I came across this very crooked/off.  So kinda a dillema on where the accurate line to cut should be.  the 10mm edge or...one mark at the bottom and just follow a straight line up.  It just looks wonky.  Without cutting anything I stopped.  Hope I described this adequately. 

This is the other half.  No problems.  Here's the troublemaker below:

 

Am I even doing this right?  I am not clear on where to cut.

[gmrhodes13[Staff]]

Some screen references posted in your build thread, you do end up with some raised section which isn't covered, mainly on the top and the bottom, they are also a bit wobbly in between. I mark 10mm in the closet to the outer ridges in a few places, use a straight edge to mark and go with that.

 

 

 

Remember too that one will be covered with a sniper plate  

[Zinfer[TK]]

Thanks man.  Glad I waited.