ANH Stunt - Centurion Visual Checklist 2024

[Sly11[Admin]]

Now updated to match current CRL requirement.

 

Note: This checklist has been updated on 1/18/2024.  wingnut65

Visual guides updated by TK-50297 Wingnut65

 

Printable PDF at bottom

 

TK50297  wingnut65 latest addition NEW Helmet exploded view fine detail visual guides suits Level 2 and Level 3.

Note: This checklist has been updated on 1/18/2024.  wingnut65

 

Printable PDF below

04 FISD ANH Stunt L3 Centurion - Ver 03 1-2024.pdf 30 ANH Stunt Helmet - Ver 02 1-2024.pdf

 

 

[BALetner]

Wow. This is nice! Thanks for posting it. 

[wook1138[TK]]

Hummm.  I don't know... I don't like that brow height.  

[TK 71627[TK]]

Hummm.  I don't know... I don't like that brow height.  

I AGREE !!! It’s TOO LOW ...

 

 

Sent from my iPhone using Tapatalk

[Sly11[Admin]]

Trouble makers lol

[Empiretrooper[TK]]

Hi Guys, can you tell me if they is a new update for 2022.
Kind regards
Tom.


Sent from my iPad using Tapatalk

[TKSpartan[Staff]]

12 minutes ago, Empiretrooper said:

Hi Guys, can you tell me if they is a new update for 2022.
Kind regards
Tom.


Sent from my iPad using Tapatalk

 

This is the last one.  

[justjoseph63[Staff]]

14 hours ago, Empiretrooper said:

Hi Guys, can you tell me if they is a new update for 2022.
Kind regards
Tom.

 

Be aware that there have been some recent CRL updates to certain items:

 

Thermal Detonator-  ANH Stunt/Hero and ESB (Basic 501st approval)

The raised ribbed section of the white control panel faces the rear, with the round washer detail closest to the right end cap.

Vertical (straight) sections of clips do not extend past the bottom of the canvas belt.

End caps shall be approximately 20 mm in width.

 

Thigh ridges- ANH Stunt/Hero and ESB (Centurion)

Lower thigh ridge joins (front and rear) shall butt-up flush against each other. Any gaps must be backed with ABS or filled as not to be noticeable.

Any mobility cuts on the back do not extend beyond the top of the raised ridges.

 

Large ab button plate-  ANH, ESB and ROTJ (Centurion)

The large Ab plate detail shall be a separate piece attached to the raised center mounting area.

Plate does not overlap the edges of this area and should show a definite straight cut edge around all sides.

 

Ear placement-  ANH and ESB (Centurion)

Ideally, placement of ears (and screws) should closely follow the rear angle of trap above them.

 

ESB hand plates (Centurion)

Curve at front of hand plates shall be positioned to sit directly over the knuckles.

 If silk or satin gloves are worn, the hand plates have the correct visible stitching with a 5 point/star pattern, equally spread out with 2 on each side and 1 in the middle front, double stitched with 2 holes at each point and sewn to the glove at each one using black thread

 

E-11 blaster - (Centurion)

T-tracks and grip shall be black with no silver/metallic weathering allowed.

[wingnut65[Staff]]

I have updated the ANH Stunt Visual Checklists, and the first post has been updated with the latest versions.