Jimmiroquai FOTK Greeblies Don’t Fit!

[Spada Rossa[TK]]

Advice needed on fitting the greeblies into the indents.  I’ll eventually curve them w a heat gun, but they’ll still be too big.

Thinking of notching out the lower edge on the front so at least the base sits flush. Top edge will still extend past the indent. 
What has everyone else done?

[Sly11[Admin]]

I know this sounds rather obvious but I shall ask anyway, Have you checked all the clip greeblies are the same size in the kit?

[ukswrath[Staff]]

You should have given smaller clips for the forearms 

[Spada Rossa[TK]]

Yep, confirming these are the smaller clips.  Larger ones for the legs are twice the size.  
Pic below sent from another builder showing the front notch I’ll be trying.   

[Spada Rossa[TK]]

[Sly11[Admin]]

That most certainly would have been my next suggestion


Sent from my iPhone using Tapatalk