Thermal detonator screws

[Aizenoso[TK]]

Hello there mates, I'm starting to file these screws to make good looking TD screws, and I want to know if I have to file/sand more or is this ok

 

4mm head diameter, 1.5mm head tall

 

Enviado desde mi SM-G955F mediante Tapatalk

 

 

[phil]

i thought its 6mm head ?

[gmrhodes13[Staff]]

I have seen 4mm to 6mm head screws used in the past. Personally I use 5mm

[Aizenoso[TK]]

I have seen 4mm to 6mm head screws used in the past. Personally I use 5mm

And about the form? Are they ok or should I file more the corners?

Enviado desde mi SM-G955F mediante Tapatalk

[gmrhodes13[Staff]]

2 minutes ago, Aizenoso said:

And about the form? Are they ok or should I file more the corners?
 

Looking from the top the flat section looks a little small, pan heads are mostly flat on top with rounded edges

 

 

[Aizenoso[TK]]

Looking from the top the flat section looks a little small, pan heads are mostly flat on top with rounded edges
 
 

Ok, then i will sand them on the top to make them flat, thanks!!!

Enviado desde mi SM-G955F mediante Tapatalk

[Aizenoso[TK]]

Looking from the top the flat section looks a little small, pan heads are mostly flat on top with rounded edges
 
 

Now that I am at home, I checked my "raw" screws and seems very similar to those without doing anything to them.

I mean, I don't know, maybe a little tall? But the form seems very similar maybe?

Enviado desde mi SM-G955F mediante Tapatalk

[gmrhodes13[Staff]]

Looks pretty close, I'd go with those.