Executioner Matt black stripe

[Mworm1974[TK]]

Hi all,

 

Are there any set measurements for the matt black stripe from the front of the helmet to the rear with regards to the width?

 

Any guidance would be greatly appreciated.

 

matt

 

 

[gmrhodes13[Staff]]

No exact measurement, I started at the front between the 2nd and 3rd teeth, keep a straight line when masking up and over the top, you can see the gap between the clip and painted line on top of the helmet is wider than the actual clip, then just continue to follow in a straight line directly down the back.

 

A few references for you

 

 

Also don't miss the small extended painted section on the side.

 

 

[Mworm1974[TK]]

Thanks for that, I thought I would check before making taking the final step.