E11 Blaster Muzzle

[Peepants130[TK]]

Somewhere on a troop, the muzzle piece on my blaster went missing. It is a open barrel ANH E11.

Can someone point me in a good direction for a replacement?

 

 

[Rat[TK]]

Who makes it? That will help for sources for replacing.

Sent from my VK815 using Tapatalk

[justjoseph63[Staff]]

There are 2 alternatives you can use, Michael, resin or aluminum. 

Here is a seller on eBay that sells the resin ones:

-----------

Below is a seller I used on my last Doopydoos build to replace the muzzle.  I personally like the sharpness of the aluminum edges.  I cut off the front and had to use a Dremel to thin out the barrel opening so that it would fit, but after some epoxy, sanding and painting it came out great.

-----------

 

I also used his aluminum parts to replace the mag well, folding stock, magazine and end cap.

 

Edited September 15, 2022 by gmrhodes13
link removed no longer working

[darthcue[TK]]

I believe the one from ebay is not resin but solid plastic?


Sent from my iPhone using Tapatalk

[Harbinger[IPM]]

Resin/plastic should not matter all that much as long as the sizes are close IMO.

[justjoseph63[Staff]]

19 hours ago, darthcue said:

I believe the one from ebay is not resin but solid plastic?


Sent from my iPhone using Tapatalk

Like Brien mentioned, resin and plastic are both fairly easy to trim.  Resin can be more brittle, though, and easier to chip.

[gmrhodes13[Staff]]

If you know someone with a 3d printer you could have one made.

[Truimphmark[TK]]

Think I may have one spare I’ll have a look and it be the cost of postage from uk to where ever you are I’ll look


Sent from my iPad using Tapatalk

[Peepants130[TK]]

Sorry guys,

I haven't been ignoring you but eh, holidays.

It is a RS Props model, aluminum barrel type.

 

Thanks for the suggestions.