Commander Gree[501st] Posted July 11, 2018 Report Posted July 11, 2018 (edited) Name: Jordan Garrison/Squad: Star/Imperial Rough Riders TK-21523 Armor = AM Helmet= AM Blaster= E-11 Hyperfirm Optional Height = 6'1" Weight = 215 Boots = TK Boots Canvas belt = unknown (Second hand) Hand Plates = Justjoseph63 Electronics= Voice Electronics Maker Neck Seal = Darman's Props Holster = Unknown (second hand) Here we go! Edited July 13, 2018 by Commander Gree Added missing photo 2 Quote
CableGuy[TK] Posted July 11, 2018 Report Posted July 11, 2018 Nice work, Jordan. Best of luck for approval. :-) 1 Quote
Commander Gree[501st] Posted July 11, 2018 Author Report Posted July 11, 2018 1 hour ago, CableGuy said: Nice work, Jordan. Best of luck for approval. :-) Thank you! Quote
ukswrath[Staff] Posted July 12, 2018 Report Posted July 12, 2018 Hey Jordan Joseph or myself will be with you shortly. Quote
Commander Gree[501st] Posted July 12, 2018 Author Report Posted July 12, 2018 1 minute ago, ukswrath said: Hey Jordan Joseph or myself will be with you shortly. Quote
illusionz_09[TK] Posted July 13, 2018 Report Posted July 13, 2018 Looks great. Nice Job! should be an easy approval. My only future critique would be to change the TD screws to pan head instead of flat. Move Along! 1 Quote
Commander Gree[501st] Posted July 13, 2018 Author Report Posted July 13, 2018 30 minutes ago, illusionz_09 said: Looks great. Nice Job! should be an easy approval. My only future critique would be to change the TD screws to pan head instead of flat. Move Along! The screws I am using were sent to me by either @justjoseph63 or @ukswrath, I ordered a set from Joseph and Tony sent some with his TD clips, so I believe they are L3, might just be the angle of the photo Quote
ukswrath[Staff] Posted July 13, 2018 Report Posted July 13, 2018 1 hour ago, Commander Gree said: The screws I am using were sent to me by either @justjoseph63 or @ukswrath, I ordered a set from Joseph and Tony sent some with his TD clips, so I believe they are L3, might just be the angle of the photo If you bought the TD clips from me then the screws are correct, if you got the screws from Joseph then the screws are correct. I can't vouch for anyone else 2 Quote
Commander Gree[501st] Posted July 13, 2018 Author Report Posted July 13, 2018 20 minutes ago, ukswrath said: If you bought the TD clips from me then the screws are correct, if you got the screws from Joseph then the screws are correct. I can't vouch for anyone else Tony, here is the Etsy transaction #1429394354. ordered from you on May 1st of this year. just in case there are any issues. I can also try and take a better photo if need be Quote
ukswrath[Staff] Posted July 13, 2018 Report Posted July 13, 2018 Just now, Commander Gree said: Tony, here is the Etsy transaction #1429394354. ordered from you on May 1st of this year. just in case there are any issues. I can also try and take a better photo if need be lol I know you purchased them from me, my point was either from me or Joseph you would have been covered 1 Quote
ukswrath[Staff] Posted July 18, 2018 Report Posted July 18, 2018 Hey Jordan, thank you for your EIB application. CRL and EIB Application Requirements:Looks like all the required submission photos have been posted. Your armor appears to display all necessary element as set out in the level 2 CRL. Beautiful job your build, Joseph and I would like to welcome you to Expert Infantry. Congratulations trooper. Other-Armor Fit/Assembly:In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor. If any suggestion affects any application it will be listed separately in the above or below sections. We have a few minor issues to go over so let's get to it. Starting at your helmet, the outer edge line on the ear rank bar does not match the tears and traps. We're suggesting you thicken them up a bit. Reference photo Next up, shoulder bell gap. We generally like to see minimal gap between the shoulder bells and the chest and back plates. Though your gap is minor the difference between the front and back views is what caught our attention. We're suggesting you remove as much gap as possible or at minimum even out the front and back. Reference photo Bicep to forearm gap. Being you're a tall trooper we take that into consideration. Our suggestion is if possible lower your bicep even further to help reduce the gap between the two armor sections. Reference photo Hand plate gap. Not sure how your hand plates are secured to your rubber gloves but they appear to be either too far forward or not very secure. We're recommending you reposition the guards, re-secure or both. Reference photo Jumping down to the waist belt, the ammo belt corners should be aligned with the outer edge of the cloth belt. The red lines drawn illustrate where the ammo belt should reside. Reference photo Holster attachment, though the holster can be attached by snaps as you have it, rivets or Chicago screws are considered more accurate. Reference photos And finally dropping down to the thigh ammo pack. The rear upper corners should be squared vs rounded. I know this isn't the best reference photo but you get the idea. Centurion Suggestions:In this section we prepare you the best we can for Centurion. If there are any areas of concern they will be discussed here. At this time there's nothing we can see that will hold you up from a clean Centurion application if you choose to apply. Congratulation again, great job 1 Quote
Commander Gree[501st] Posted July 18, 2018 Author Report Posted July 18, 2018 17 minutes ago, ukswrath said: Hey Jordan, thank you for your EIB application. CRL and EIB Application Requirements:Looks like all the required submission photos have been posted. Your armor appears to display all necessary element as set out in the level 2 CRL. Beautiful job your build, Joseph and I would like to welcome you to Expert Infantry. Congratulations trooper. Other-Armor Fit/Assembly:In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor. If any suggestion affects any application it will be listed separately in the above or below sections. We have a few minor issues to go over so let's get to it. Starting at your helmet, the outer edge line on the ear rank bar does not match the tears and traps. We're suggesting you thicken them up a bit. Reference photo Next up, shoulder bell gap. We generally like to see minimal gap between the shoulder bells and the chest and back plates. Though your gap is minor the difference between the front and back views is what caught our attention. We're suggesting you remove as much gap as possible or at minimum even out the front and back. Reference photo Bicep to forearm gap. Being you're a tall trooper we take that into consideration. Our suggestion is if possible lower your bicep even further to help reduce the gap between the two armor sections. Reference photo Hand plate gap. Not sure how your hand plates are secured to your rubber gloves but they appear to be either too far forward or not very secure. We're recommending you reposition the guards, re-secure or both. Reference photo Jumping down to the waist belt, the ammo belt corners should be aligned with the outer edge of the cloth belt. The red lines drawn illustrate where the ammo belt should reside. Reference photo Holster attachment, though the holster can be attached by snaps as you have it, rivets or Chicago screws are considered more accurate. Reference photos And finally dropping down to the thigh ammo pack. The rear upper corners should be squared vs rounded. I know this isn't the best reference photo but you get the idea. Centurion Suggestions:In this section we prepare you the best we can for Centurion. If there are any areas of concern they will be discussed here. At this time there's nothing we can see that will hold you up from a clean Centurion application if you choose to apply. Congratulation again, great job YAY!!!! Thank you so much for your time! I will get on these fixes right away and will have my Centurion app in before the next rebellion! 3 Quote
Berbs42[TK] Posted July 18, 2018 Report Posted July 18, 2018 CONGRATULATIONS! And Welcome to EIB, Trooper!!! WOOT!! Crap, now you're gonna beat me to Centurion aren't you?!?... 1 Quote
Commander Gree[501st] Posted July 18, 2018 Author Report Posted July 18, 2018 2 hours ago, Berbs42 said: CONGRATULATIONS! And Welcome to EIB, Trooper!!! WOOT!! Crap, now you're gonna beat me to Centurion aren't you?!?... Yes, yes I am, but hello, we have 300 armor parties between now and the end of the year lol. We can work on yours as well Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.