TK-92802 Requesting ANH Stunt EIB Status [ANOVOS] [782]

[Harbinger[IPM]]

General Information

Name: Brien Edick

FISD Name: Harbinger

501st ID: 92802

Profile Page: http://www.501st.com/members/displaymember.php?userID=26568&costumeID=124

Garrison: Central California Garrison

 

Mandatory Information

Armor Maker: ANOVOS

Helmet Maker: ANOVOS

Blaster Type: Praetorian Blasters ANH E-11

 

Additional Information

Height: 5' 7"

Weight: 180 lbs

Boots: TKBoots

Canvas Belt: TKittell

Gloves: Home Depot

Hand Plates: justjoseph63

Electronics: N/A

Neck Seal: ANOVOS

Holster: ANOVOS

Build Thread: https://www.whitearmor.net/forum/topic/43244-harbingers-first-build-anh-stunt-tk/

 

Armor Photos (Click for Full Size)

Full Body Front:

 

Full Body Back:

 

Full Body Right:

 

Full Body Left:

 

Right Side Detail:

 

Left Side Detail:

 

Ab Button Detail:

 

Helmet Detail Photos

Helmet Front:

 

Helmet Back:

 

Helmet Right:

 

Helmet Left:

 

Helmet Hovi Detail:

 

Helmet S-Trim Detail:

 

Helmet Lens Color:

 

Helmet Right Ear/Screw Detail:

 

Helmet Left Ear/Screw Detail:

Accessory Photos

Belt Front:

 

Belt Back:

 

Thermal Detonator Front:

 

Thermal Detonator Back:

 

Neckseal:

 

Hand Guards:

 

Boots:

 

Blaster Right:

 

Blaster Left:

 

Blaster D-Ring:

 

Armor Detail Photos

Thigh Ammo Right:

 

Thigh Ammo Left:

 

Thigh Ammo Rivet Detail:

 

Sniper Knee Right:

 

Sniper Knee Left:

 

Cod Rivet Detail:

 

Posterior Snap Detail:

 

Interior Strapping:

 

Known Issues (Centurion To-Do's)

• Tighten Shoulder/Bridge gap (need new elastic)

• Mic Tip Mesh

• Re-paint Vocoder Details

 

Action Shot!

Edited December 3, 2017 by Harbinger

[Harbinger[IPM]]

Noticed the belt was a bit low after all the photos, so I added some Velcro:

 

(Too lazy to put thighs on.)

[magni[TK]]

Looking good!

Best of luck Brien!

[CableGuy[TK]]

Looking great.  Good luck, Brien. :-)

[Shanester[TK]]

Very nice build.  Best of luck! 

[TK8776 jgarrettg]

You did a great job putting that together Brien.

[ukswrath[Staff]]

Hey Brien thank you for your EI application. 
CRL and EIB Application Requirements:
All the required submission photos have been posted. Beautiful job on your build . Your armor meets all EIB requirements, Andrew and myself are delighted to welcome you to Expert Infantry. Congratulations  

 

Other-Armor Fit/Assembly:
In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor and accuracy. If any suggestion affects any application, it will be listed separately in the above or below sections. Again, these are suggestions and recommendations. The accuracy is ultimately up to you. 

 

Your helmet Vcoder lines could use a little more definition as seen in the provided reference photo. We're recommending you touch up the following areas.  

 

Reference photo

 

The Hovi tip screens should be a heavier weave. We're recommending you replace these

 

Reference photo

 

Next up is the shoulder bell gap. There should be minimal gap between the shoulder bells and chest/back plates. This may be a simple photo issue, if not do the best you can to bring these in as close as possible. Tightening the straps and removing any lower return edge tends to help the most.

 

Reference phoito

 

And finally, the right side of the sniper knee looks to be protruding out a bit. We're a little concerned it might get snagged on something.

 

Centurion Suggestions:
In this section we prepare you for your Centurion application if you choose to apply. If there were any areas of concern they would be discussed here. At this time we have nothing to add. That's it, great job. Hope to see you at Centurion. 

[CableGuy[TK]]

Congrats, Brien. Good job. :-)


Sent from my iPhone using Tapatalk

[gmrhodes13[Staff]]

Congratulations and welcome to the ranks trooper

[Harbinger[IPM]]

11 hours ago, CableGuy said:

Congrats, Brien. Good job. :-)


Sent from my iPhone using Tapatalk

Thanks! You too

 

Thanks everyone. Now on to L3.