TK-99924 Requesting ANH Centurion Status (Anovos) [362]

[CommanderRaider[TK]]

NAME: David Sihombing
ID#: TK-99924
FORUM: CommanderRaider (aka RAIDER)
GARRISON: Florida Garrison/Tampa Bay Squad

Armor Make: Anovos

Blaster: Unknown...purchased from Rob Somerville/UKG (if that helps any)

Hand Guards: Joseph Pedigo

Boots: TK Boots

Belt: Rob Kittell

EIB Link:

[CommanderRaider[TK]]

 

 

 

 

 

 

[CommanderRaider[TK]]

 

 

 

 

 

 

 

[CommanderRaider[TK]]

 

 

 

 

 

 

 

 

 

[CommanderRaider[TK]]

 

 

[ukswrath[Staff]]

Hey David welcome. Before we get started please post the following information at the top of the page. Afterwards please post photos of the forearms (wrist side) and all 4 helmet sides please.

 

Armor Make:

Blaster Type: 

EIB Link: 

[Shanester[TK]]

That is a might fine looking TK right there.  Good luck trooper! 

[CommanderRaider[TK]]

Thanks Tony! I'll get the additional pics up tonight when I get home.  Here is the info (plus some extras) you requested:

 

Armor Make: Anovos

Blaster: Unknown...purchased from Rob Somerville/UKG (if that helps any)

Hand Guards: Joseph Pedigo

Boots: TK Boots

Belt: Rob Kittell

EIB Link:

Some added info

 

THANKS SHANE!

Edited November 28, 2017 by CommanderRaider

[Harbinger[IPM]]

You might want to raise your forearms up 1/4-1/2" to close the gap between your biceps/forearms a little, and also prevent handguard chipping from the forearms rubbing against them.

[CommanderRaider[TK]]

You might want to raise your forearms up 1/4-1/2" to close the gap between your biceps/forearms a little, and also prevent handguard chipping from the forearms rubbing against them.

 

Thanks. Yea I have some long behind arms so thats been an issue (they come in handy on a basketball court lol). I’ve adjusted them a few times and either the gap at the wrists ends up looking too far apart or the gap at the elbow. I think my EIB submission even shows some adjusting (at least from my initial approval photos to the EIB).

 

 

Sent from my iPhone using Tapatalk

[CommanderRaider[TK]]

 

 

 

 

 

 

Sent from my iPhone using Tapatalk

 

[ukswrath[Staff]]

So before we get started the only concern we have is the back plate to kidney overlap. The CRL states: For level three certification (if applicable): Back plate shall have no, or minimal overlap of the kidney plate.

 

Looking back at your EIB you were fine but now we have overlap. We're not sure why that is but if you could post new back, left and right side photos without the overlap that would be awesome.

 

 

[CommanderRaider[TK]]

So before we get started the only concern we have is the back plate to kidney overlap. The CRL states: For level three certification (if applicable): Back plate shall have no, or minimal overlap of the kidney plate.
 
Looking back at your EIB you were fine but now we have overlap. We're not sure why that is but if you could post new back, left and right side photos without the overlap that would be awesome.
 

 

Will do. Anything else? Thanks!


Sent from my iPhone using Tapatalk

[ukswrath[Staff]]

Nope, that's it

[NINJAM0VE[TK]]

Good Luck David! You are almost there!

[CommanderRaider[TK]]

Round 2...hopefully the gaps are fixed.  Wife was getting frustrated w/ the belt lolololol (saying I gained weight haha)...so we called it a night w/ these...

 

 

 

 

 

 

 

 

[ukswrath[Staff]]

Thanks David we'll be with you shortly

[ukswrath[Staff]]

Hey David welcome back and thank you for your Centurion application.

CRL and Centurion Application Requirements:

All required submission photos are present. Andrew and I are pleased to say your armor displays all the elements as set out in the Centurion CRL. Congratulations and welcome to Centurion     

 

Other-Armor Fit/Assembly:

Centurion is the ultimate level in accuracy. Here you want your armor looking as canon as possible however, ultimately it's is up to you to decide. Thank you for updating recommended areas suggested during your EIB application. Continuing along the same lines we're highly recommending you resolve the following issues also mentioned in your EIB app. 

 

Incorrect ear screws. The screw type should be "V" head not "Pan" head. 

 

Reference photo

 

Soft Vcoder lines

 

Reference photo

 

Waist belt a bit low. 

 

Reference photo

 

That's it. Great job on your build. Now it's time to get out there and make the Empire proud trooper 

[Shanester[TK]]

Congrats and welcome to Centurion trooper! 

[CommanderRaider[TK]]

Awesome!  Thanks guys!!!  Now to find a rocker lol!!!  Thanks again!

[Harbinger[IPM]]

Congratulations!