My E11 WIP!

[The Anonymous Egyptian]

I received my E11 kit back in February, so it's been quite a while in the making.

Could I get some feedback before I go and spray it? Thanks

[justjoseph63[Staff]]

Great job on that build, Omar!  Just a few things I noticed may help it to look even better:

 

1.  The scope rail seems to be sitting a bit high.  This may be due to the fact that (in the photos) it is not connected to the rear sight correctly as seen in the photo below from the FISD blaster reference thread;

 

 

2.  You are missing the charging handle.

 

3.  You didn't show a photo of the D-ring, but judging from the tiny bit shown in the third photo it looks as if you used the one that came in the DD kit.  This will probably need to be replaced.

 

Overall a terrific build, and fantastic job on removing the Power cylinders!!

[The Anonymous Egyptian]

 

 

Overall a terrific build, and fantastic job on removing the Power cylinders!!

Ah brilliant to hear, had a long thought session as to where the scope rail should sit . Luckily it wasn't the reverse with the rail sitting too low, at least I can undo this! The charging handle will be added post painting in order to allow movement. Could you direct me to a correct D ring by any chance? Thanks!

 

Sent from my 5022X using Tapatalk

[Troopacoola[TK]]

Getting there bud. As Joseph said, get the rail to fit a little closer to the main body, and replace the d ring.

[Bulldog44[TK]]

Looking good. Will you be adding the counter too? Good luck with the paint job. Check out the blaster reference guide in the weapons section under ANH blasters. Lots of useful info!

[The Anonymous Egyptian]

Looking good. Will you be adding the counter too? Good luck with the paint job. Check out the blaster reference guide in the weapons section under ANH blasters. Lots of useful info!

Not for this one! ESB blasters don't have them by the looks of things

 

Sent from my 5022X using Tapatalk

[The Anonymous Egyptian]

 

How's this?

Edited May 1, 2017 by The Anonymous Egyptian

[Troopacoola[TK]]

Lots better bud!

 

Sent from my SM-G920F using Tapatalk

[Troopacoola[TK]]

Ah brilliant to hear, had a long thought session as to where the scope rail should sit . Luckily it wasn't the reverse with the rail sitting too low, at least I can undo this! The charging handle will be added post painting in order to allow movement. Could you direct me to a correct D ring by any chance? Thanks!

 

Sent from my 5022X using Tapatalk

Try mark shearman ( triumphmark ) on the ukg

 

Sent from my SM-G920F using Tapatalk

[The Anonymous Egyptian]

Spraying underway

[Bulldog44[TK]]

Sorry , I always assume people are building ANH style blasters.

[The Anonymous Egyptian]

Sorry , I always assume people are building ANH style blasters.

Don't apologise!! I'm just an edgy ESB fan who wants to be awkward!

[Toddahhhh[TK]]

For my D ring, I used a link from a hanging light fixture chain, it worked perfect.

 

 

Sent from my iPhone using Tapatalk

[The Anonymous Egyptian]

There ya go folks

[justjoseph63[Staff]]

 

How's this?

 

 

That looks MUCH better, Omar!  Don't forget the screw, though..