MandalorianWarrior87 Posted July 19, 2008 Report Posted July 19, 2008 Was just wondering what everyones preferred way of cutting out the eyes is. I'm having a little trouble trying to without slipping with a craft knife. This is my first bit of kit and first time aswell. Would appreciate any help i can get Thanks in advance. Quote
giric thren Posted July 19, 2008 Report Posted July 19, 2008 I got a pencil and ran it along the inside edge of the eye thenI used a dremmel with the "wand" attachment, and when I got withing a few cenimeters of the pencil mark. Next I went to lowes and bought some small files (come in a pack for $10-20) and carefully filed to the edge. I then took some sandpaper of various grit and started sanding untill I was happy. After all that was done I went to Walmart and in the Auto section, I boght some 2000grit sandpaper and smoothed out the edges. That worked pretty well for me Quote
Murray1134[501st] Posted July 19, 2008 Report Posted July 19, 2008 You could try using the sanding attachment for a dremel or something similar. I would check the AP/TE Forums on here or the "OMG Rebuild" thread for hints. Quote
MandalorianWarrior87 Posted July 19, 2008 Author Report Posted July 19, 2008 Thanks for the help I'll try using the dremel i think, just scared i'll mess it up Quote
troopermaster Posted July 20, 2008 Report Posted July 20, 2008 I start off by marking the outlines with a pencil where I want to cut. I like to drill three holes, one in each corner of the eye sockets using small drill bit about 5mm. Then using a Stanley knife, I score a line between each hole on the inside of the helmet. Do a couple of light passes until the blade comes through and you can remove the triangle shaped piece. Then using the sanding wheel on my Dremel, I sand the remaing plastic away from the inside of the helmet to avoid any slips which will mark the outside face. Then you can go over the edges with some sandpaper for a really smooth finish. Quote
missingpieces[501st] Posted July 20, 2008 Report Posted July 20, 2008 like everyone has pretty much said pencil the eyes, drill some holes, and dont forget to TAKE YOUR TIME CUTTING AND CONTIUNE BREATHING! lol! personally, i use an exacto knife for the final trimming. Quote
MandalorianWarrior87 Posted July 21, 2008 Author Report Posted July 21, 2008 I started with a craft knife but didnt like it so i've switched to drilling holes and using a "wand" type attachment thingy, lol. So far i've only cut one eye (still need to sand) Gonna start on the other later on today. Taking it real slow, lol. Thanks again guys. Edit. Well, cut out most of the other eye, just need to sand both and then start on the teeth Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.