SeanTX Posted September 24, 2015 Report Posted September 24, 2015 I know I'm not the first to experience this but I haven't stumbled on and info on the topic. But alas my brother has a fat head. And his head barely fits through the bottom of his helmet without the rubber edge seal. So with it he will never fit. My initial thoughts were to widen the hole a 1/4" all the way around. But I feel this might get to close to the screw holes on the lower ears. Is it better to widen only certain areas of the helmet hole? Quote
Sonnenschein Posted September 24, 2015 Report Posted September 24, 2015 (edited) Repositioning the face and cap'n back gives you some space. And most people have to put the helmet on sideways and "screw" it on. Widening like you want to is an option too, but it still should be an oval opening. Edited September 24, 2015 by Sonnenschein 2 Quote
Scarlet Trooper[501st] Posted October 13, 2015 Report Posted October 13, 2015 My husband has a fat head too. He does what Sonnenschein stated about putting the helmet on sideways. We did try to make his helmet a little wider than mine, but he can still put my helmet on his head as well. Quote
Coastertk Posted October 13, 2015 Report Posted October 13, 2015 If you're not screwing it on you're doing wrong. Quote
HouTK418[501st] Posted October 16, 2015 Report Posted October 16, 2015 I can BARELY get mine on even when screwing it on.. in armor with restricted movement it's virtually impossible.. I need options as well. member of the fathead brigade. Quote
Airborne Trooper[501st] Posted October 16, 2015 Report Posted October 16, 2015 I widened mine a bit more but be careful not to go too high. You don't want to remove going into the tube section of the curve. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.