Scorcher's AM 2.0 Hero (first build)

[Scorcher]

Hi all.

So my box arrived last week, and I went shopping for some supplies last night.  Decided after work today to kick off my helmet.

 

Teeth are done:

 

Brow fitted and cut, how does the brow and faceplate positioning look?

 

[Bone[501st]]

Hey Eliza,

 

teeth are looking good.

What are you going to do with the surplus teeth to make it a hero?

 

ABS paste or heat?

[Scorcher]

It was suggestesd to me to heat them then even it up with ABS paste, but to make basic apparently this step isn't necessary? I'm worried I'll stuff this step up.

[Tolo[TK]]

It was suggestesd to me to heat them then even it up with ABS paste, but to make basic apparently this step isn't necessary? I'm worried I'll stuff this step up.

I suggest the heat method for the teeth and some patience.

 

You are right , for basic approval, you don't need to have the three teeth on each side or the 3 bumps on the ear. But, if you don't want to go a tye way, I suggest you to paint the teeth correctly, so you can be identified better.

 

 

Sent from my iPhone 6 using Tapatalk

Edited February 19, 2015 by Tolo

[justjoseph63[Staff]]

Just a quick note...  If you decide to go with the 3 bump ears bars, you can try ATA.  I believe they run about $13.00 or so for the set of 2.  Might save you a lot of work if you decide to go EIB or Centurion.

[SCTrooper[TK]]

You can use the ears that came with the kit. Grind off the 2 bumps in the middle and then add one bump back the middle with some bondo. This will be hidden under the gray paint.

 

Hope this helps,

 

Nick