SEANTX AM 2.0 Stunt

[SeanTX]

6'2"

 

I tried to get it to ride a little higher to eliminate the gap. But plastic just naturally snaps into that spot. It didn't need glue or anything to keep from falling.

 

I think I may have my thighs to high. Which could be half the issue.

[Airborne Trooper[501st]]

try dropping your thighs down a notch

[SeanTX]

Basic approval complete. TK 73268

 

Updated chemical glove picture

 

Finished boots just cause I'm proud.

 

 

And elastic retention bands added at long last.

[LoveMonkey[501st]]

Congrats!

 

 

Sent from my iPhone using Tapatalk

[SeanTX]

Thanks

[SheaJeff[TK]]

I actually wound up heating the cheek and pushing it out. You can't tell other than the gap is eliminated.

 

 

I'll measure the ammo boxes as soon as I get home.

 

I'm having the same issue with the ears on my AM 2.0 helmet, especially the left one!  The cheeks need to come out a lot.

 

What did you use to heat it?  Heat gun?  Hair dryer?

Where did you heat it at?

[SeanTX]

Yep. Just light heat gun application and thumbs

 

Sent from my SAMSUNG-SGH-I257 using Tapatalk

[pewpewpew[TK]]

I'm having the same issue with the ears on my AM 2.0 helmet, especially the left one! The cheeks need to come out a lot.

 

What did you use to heat it? Heat gun? Hair dryer?

Where did you heat it at?

I stuffed a piece of foam pool noodle in the tube and clamped everything tight for a few days to close the gaps up. Took the clamp off after a few days and everything stayed tight. I think there's a pic of this in my build thread somewhere.