tazdevilal Posted July 28, 2014 Report Posted July 28, 2014 Hi. This is just a quick question that probably has been asked before but as I have finished my vac table and a surge tank set up also made up I am looking for a decent vac pump to use INDOORS. The tables got a vac surface of 60cm square and if my calculations are right there are 2 6ltr tanks for holding the air. I have seen a few options and they are around 1.5 too 4 CFM and have an HP of 1/4. This is a range of pics of my table set up http://www.whitearmor.net/forum/topic/27868-vacuum-forming-table-pump/page-2#entry353775 All help as usual greatly appreciated Quote
SuperTrooper Posted July 30, 2014 Report Posted July 30, 2014 Check out HVAC supply shops. They will have vac pumps and the sky is the limit on how much air they will move. Quote
tazdevilal Posted July 30, 2014 Author Report Posted July 30, 2014 Cheers for that. I was looking at that site. I'm only looking to do minimum pulls. Currently trying my hand at pepakura build. Done the helmet but not started hardening it. Going to make it into a mold a use it to pull some HIPS. Should really start showing off my new pride and joy before getting to far ahead in the helmet and armour so people believe me lol Quote
walt[501st] Posted July 30, 2014 Report Posted July 30, 2014 As a good rule of thumb....more cfm the better Quote
tazdevilal Posted July 30, 2014 Author Report Posted July 30, 2014 (edited) Thanks again Walt. Is there a did between a single and 2 stage pump? Looking at a budget of £150 uk Edited July 30, 2014 by tazdevilal Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.