help- detonator

[TKedt[TK]]

any ideas on the clips to fix the thermal detonator to the belt? something cheap I can find at the hardware store or other.

[I'm Batman[501st]]

http://www.whitearmor.net/forum/topic/14283-how-to-make-thermal-detonator-belt-clips/?hl=%2Bthermal+%2Bdetonator

 

All of about $2.00 for the srtrip of aluminium. Cheap enough?

[Sly11[Admin]]

It's funny, you are asking all the same questions I was asking only a short while ago. Many hard ware stores sell the aluminium strips in various lengths and widths, you need 25mm width or 1 inch, but don't get anything thi her than a couple of mm or it's too difficult to bend

 

 

Sent from my iPad using Tapatalk

[Sly11[Admin]]

Sorry, thicker than a couple of mm's

 

 

Sent from my iPad using Tapatalk

[gazmosis[501st]]

Where do you live, Ed? If you are in the US, Lowes sells what you need: 1 inch by 1/16 aluminum strip. I think it's $7 for 8 feet of it.

[TKedt[TK]]

Where do you live, Ed? If you are in the US, Lowes sells what you need: 1 inch by 1/16 aluminum strip. I think it's $7 for 8 feet of it.

I live in Michigan . 8 feet? I just need a little bit. Do they sell it in small quantities?

[gazmosis[501st]]

Sadly no......but it will not go to waste. If you have never made TD clips before, you might need a little extra. Then you can show yours off and make a set for a Garrison mate or two.

[Sly11[Admin]]

That's a good call gaz

 

 

Sent from my iPad using Tapatalk