A Master Builder Posted June 19, 2014 Report Posted June 19, 2014 On my Thermal detonator, it came untrimmed when it arrived. I trimmed both end caps and outing for the canister. After having it fully put together, I came across the whole TD being too long. Has anyone ran into this problem? was I supposed to trim the tube a little? Now the end caps do look a little funky, maybe had trimmed too much off of them. Here it is. Quote
usaeatt2 Posted June 19, 2014 Report Posted June 19, 2014 Total length with caps should be 7.25 to 7.5 inches. Caps should measure just under 13/16". Quote
Cantina Security[501st] Posted June 19, 2014 Report Posted June 19, 2014 According to Aaron's killer measurement reference , it looks like your not to far off. Should be ok for trooping. Quote
gazmosis[501st] Posted June 19, 2014 Report Posted June 19, 2014 There is a little visual deception here. According to your measurement, you are only 1/8 inch long which is no big deal. You need to remember that the AP thermal detonator is a smaller diameter than the screen used one by almost 1/4 inch. Yours will look longer for this reason. What I would concern myself with is getting your clips properly positioned to the end caps with close to no gap. Quote
A Master Builder Posted June 19, 2014 Author Report Posted June 19, 2014 (edited) Thanks guys. It's 2mm over 7 1/2inches. I'm going to chim 1 mm off both side of the pipe. Then move the clips to right by the ends caps. Thanks Brenton Edited June 19, 2014 by Mickey Mouse Quote
usaeatt2 Posted June 19, 2014 Report Posted June 19, 2014 There is a little visual deception here. Parallax error strikes again! Quote
A Master Builder Posted June 19, 2014 Author Report Posted June 19, 2014 About to post after pictures and they will be better quality! Quote
Dark PWF[Staff] Posted June 19, 2014 Report Posted June 19, 2014 There is a little visual deception here... You need to remember that the AP thermal detonator is a smaller diameter than the screen used one by almost 1/4 inch. All I hear in my head is Vector from Despicable Me: "CURSE YOU, TINY TD!" Quote
A Master Builder Posted June 19, 2014 Author Report Posted June 19, 2014 All I hear in my head is Vector from Despicable Me: "CURSE YOU, TINY TD!" HAHAHA, Good One Tim! Quote
usaeatt2 Posted June 19, 2014 Report Posted June 19, 2014 Nicely done. Can't even tell it ever looked different! Quote
MrDiez[TK] Posted June 28, 2014 Report Posted June 28, 2014 Nice job. Where did you get the screws? Are those round headed? Sent from my iPhone using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.