Magazine size

[Truimphmark[TK]]

Hi guys if any of you can help I'm doing a deact in to an E11 need to know size (lenght) of the magazine to be cut down to outside sizes. Please if anyone cane help:-)

[TK bondservnt[501st]]

heres a good rule of thumb

 

[Truimphmark[TK]]

Cheers Vern but have you got sizes for the mag.

[gazmosis[501st]]

There is no concrete measurement. Just trim it just beyond the mag lock clip on the back...an inch past

[Truimphmark[TK]]

Cheers Steve taken on board what you've said and also looked at the pic that Vern's supplied measuring stick out looks like around half half from pic and your measurement hits smack bang on a spot weld so I'll do just off the spot weld for strength of the metal for bending over the ends once again thank you for your input cheers buddy.