Cutting sds sniper knee

[Code]

Hi, all I'm getting round to attaching my sniper knee properly. I've marked in pen what I think needs cutting,is this right?

 

 

 

I know the holes are wrong too and it needs raising but do I also need to trim some more off either end edge?

 

Thanks as always

[rhapsodyred99[TK]]

Usually the return edge is about 1/4 inch its hard to see from the white there but it looks like the line should come below the screw you have there.... let me see If I can get a pic of my TM...

 

Edit:

 

the TM will not help it is not the same as the SDS so showing a pic of it would not help. There is a centurion thread that used SDS that you may be able to use as a guideline.

Edited November 25, 2012 by rhapsodyred99

[Code]

Thanks for the reply, I found the thread you mentioned and I came up with this