If riveting the ammo belt to the canvas belt...

[kevnaminute]

What size rivets is good? And type? Thanks all

[gmrhodes13[Staff]]

From what I have read there is no set size or type just try to use something shallow so it's not constantly rubbing on the armor. I was thinking about covering the back of the rivet with duct tape or silicon

[Darth Hilarious]

the rivets are only visible on RotJ kits (and not all of them)

So it might not matter much

Shallow is good, as Glen pointed out

[troopermaster]

You should use single cap rivets - not pop rivets. 7mm x 7mm is a good size. Pop rivets will rub against your armour where single cap rivets are flat and won't rub, and they're screen accurate too.

Edited November 18, 2012 by troopermaster

[kevnaminute]

Thanks all!