Thermal detonator screws ?

[DudeSidious]

I cant seem to find the flat head screws that attach the detonator to the two aluminum strips.

Can someone point me in the right direction where to get these?

[Locitus[Admin]]

Any flat head screws would work in my opinion. May want to get the counter sunk variant though.

[TK bondservnt[501st]]

I use round top slotted head 6/32" bolt and nut steel

 

troopermaster uses round head slotted like this.

 

flat head slotted would work for helmet ears.

[DudeSidious]

my local hardware store only has the Philips head screws.

I seen a picture somewhere (cant find it now) of a screen used detonator and they used the non counter sunk type.

[Locitus[Admin]]

Then I suggest using the non counter sunk type. I used counter sunk, but my clips from Jesse have counter sunk holes so it made sense to me. For holes that aren't counter sunk a non counter sunk screw should be a better fit (and I doubt the SW costume department would take the time to fix the clips like that on all 50 or so detonators).

[TK bondservnt[501st]]

the tops on troopermaster's screws are round, slotted. not flat countersunk.

[DudeSidious]

sounds good,Is there somewhere online I can get these?

[Locitus[Admin]]

These should fit ----------

Edited December 22, 2021 by gmrhodes13
link not working removed

[DudeSidious]

think I found some but 64 to many---------

Edited December 22, 2021 by gmrhodes13
link not working removed