tbo Posted May 30, 2012 Report Posted May 30, 2012 After trying to hand paint my RT-Mod helmet versus use decals I found myself having quite a bit of troubles with the Humbrol paints.. The end result was a very thick and nasty looking coating of something that sort of resembled paint. I had done a few searches trying to find things to remove it, and after finally making a post someone recommended using oven cleaner. This was done quite a while ago and I just recently found the free time to get back to my build, but I thought I would share the results. I take around the trap and sprayed it two or three times. It would foam up so I would apply more after it settled. It has been sitting for approximately 18 hours or so and it started cracking and bubbling up and one swipe with a rag showed a good clean removal with no damage to the plastic. Enjoy! Quote
Sonnenschein Posted May 31, 2012 Report Posted May 31, 2012 I told you it'll work Sure, it is time consuming, but it save a lot of elbow grease Quote
TK bondservnt[501st] Posted May 31, 2012 Report Posted May 31, 2012 testors paint or humbrol? hips or abs? Quote
Sonnenschein Posted May 31, 2012 Report Posted May 31, 2012 testors paint or humbrol? hips or abs? Doesnt matter. Quote
tbo Posted May 31, 2012 Author Report Posted May 31, 2012 long soak time? 10 hours? I let it sit for like 18 hours the first time and came off fine. I sprayed a few other spots and after about four hours it appeared to look as it did at 18. I wasn't in a hurry so I let It sit I over night. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.