Adding D-Ring To Hyperfirm?

[Hedjii72]

I have a Hyperfirm E-11, and I'd like to add a D Ring to it.

 

I ordered a D Ring from Trooperbay, but the ring is a closed loop, and it looks like it would be difficult to attach to the Hyperfirm. Has anyone here done this mod, and can you share some insight on how to do it?

 

I was thinking I'd just drill a hole straight through the rubber block on the back and thread both ends of th e D Ring through, but this one from Trooperbay is solid, and unmaleable.

 

Any thoughts?

[DarkTrooper[TK]]

I cut off about 1/4" off the straight side of the d-ring, drilled through the end cap of the hyperfirm and worked the ring through it.

[SolderMaster]

I used a 1/16" drill bit to drill through the end cap. Then I used 2 pliers and bent the D-ring so I could slide it into the hole I drilled. Then, bend back with the pair of pliers. DONE

[vecspeed12]

I used a 1/16" drill bit to drill through the end cap. Then I used 2 pliers and bent the D-ring so I could slide it into the hole I drilled. Then, bend back with the pair of pliers. DONE

 

This is exactly how I did mine.

[xaoslord]

You can see how I did mine on this post in my build thread:

 

http://www.whitearmo...=20#entry226314

Edited May 1, 2012 by xaoslord

[n0c00lgamertag]

 

 

This is exactly how I did mine.

 

Ditto.

[tgibson43]

I found a 1/16" drill bit a bit - heh, get it - too small. 7/64" worked perfectly for me. Not too big that it moves around but not too small that i was struggling to get it through. 

[danegeld[501st]]

sweet now i know what to do when I get my hyperfirm E-11

[Jaren[TK]]

Very nice! Thank you!I have been wondering how to put that on with destroying it.