Jeepfrog[TK] Posted April 29, 2012 Report Posted April 29, 2012 (edited) i am haveing a problem with the heet neck seal leaving black marks on the armor chest plate what can i do to stop this Edited April 29, 2012 by Jeepfrog Quote
dashrazor Posted April 29, 2012 Report Posted April 29, 2012 is it the neck trim ? ( the rubber gasket) or the neck seal? (cloth neck wrapping) Quote
Darth Aloha[Admin] Posted April 29, 2012 Report Posted April 29, 2012 Is your neckseal dyed? Looks like the same stuff that comes off the leather palms of my nomes gloves. Aloha, -Eric Quote
anphrax[TK] Posted April 29, 2012 Report Posted April 29, 2012 is it the neck trim ? ( the rubber gasket) or the neck seal? (cloth neck wrapping) This would be my question as well... Quote
Sonnenschein Posted April 29, 2012 Report Posted April 29, 2012 I'm sure he means neck trim. The neck seal never touches the outside of the cheat plate Quote
Jeepfrog[TK] Posted April 29, 2012 Author Report Posted April 29, 2012 It's the rubber on the lower edge of the helmet Quote
Locitus[Admin] Posted April 30, 2012 Report Posted April 30, 2012 Keep you chin up. If you haven't padded your helmet properly your helmet can tilt forward. Not only will it look like you're always looking at the floor but the trim will be closer to the chest then. Quote
dashrazor Posted April 30, 2012 Report Posted April 30, 2012 you could try putting some black duct tape over the trim in just the front (just a small strip). it shouldn't be noticeable an would stop the scuffing. Quote
Sonnenschein Posted April 30, 2012 Report Posted April 30, 2012 Applying some clear nail polish help too! Quote
Jeepfrog[TK] Posted May 1, 2012 Author Report Posted May 1, 2012 (edited) The last two events I trooped did have a lot of kids I was looking down alot maybe I will try duct tape first if it does not look to bad Edited May 2, 2012 by Jeepfrog Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.