Jump to content

Recommended Posts

Posted

Hello, finally got my armor (well, a few months back) but it has a crack in the shoulder/chest area (split)... is there some sort of putty or something I can use? Until then its pretty unwearable (too obvious).

Posted

you can support the back of the armor with fabric and glue.

 

use it like a cast from the inside.

Posted

What material is your kit? Do you have a photo? I had a piece of my TE2 chest piece split, I reinforced the back of the split with a piece of plastic clamp glued to stop it splitting further. The split was so narrow that I just had to polish it down a bit. It still might be noticeable, but I'm not gonna do more intrusive repairs unless it gets larger.

Posted

hav eyou tried using ABS paste? i fyou use the same abs as your armour it colour matches perfectly and you can sand it down afterwards, like there was no crack at all.

Posted

I would use a combination of what Bluegrot and seantrooper suggested. Support underneath with a strip of ABS or similar and then fill any seam on the outside with ABS paste (mix together abs shavings and a little acetone to make the paste) You can then sand it with 180 grit sandapaper and then again with 400 grit and use the deep scratch polish after that. Then use the other 2 polishes. Makes the crack almost invisible and you will still have a decent luster to the armor.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...