blaster dimensions

[Quebectrooper]

Hi.

I'm about to modify my Hasbro and would like to get the exact dimensions of the accurate movie Blaster.

 

Should i extend my Blaster ...

[tkrestonva[TK]]

It's not necessary to extend the blaster barrel. I suppose you could, but it's not required - even for EIB.

[TK bondservnt[501st]]

dang double post!

Edited April 25, 2010 by TK Bondservnt 2392

[TK bondservnt[501st]]

I personally dislike the hasbro because it's just so darn easy to get a doopy do's pipe kit and bang.

accurate blaster with all the space you'd need to put even the hasbro electronics inside.

 

19 3/8 " total length from folding stock front hinge to D ring mount.

 

Doopy Do's hollow pipe kit

 

actual sterling mod.

 

Doopy Do's hasbro mod.

 

if you purchase the doopy do's kit, your hasbro will look as good as it can.

 

if you go the extra mile, you could cut a lot off, and make it much more accurate.

[dashrazor]

according to my blueprints the main receiver tube is 449 mm long and the overall length is 48.2 cm

[Quebectrooper]

Thanks guys now i can get to work!

[TK bondservnt[501st]]

dashrazor which blueprints do you speak of?

 

there are several sources for blueprints. I'm looking for an accurate set.

 

I'm going to purchase a machinist's version.

 

I've seen plans produced by a guy that did an airsoft conversion and

his plans are wrong.

 

good luck on your blaster mod quebectrooper!

 

The receiver tube is not the total length.

if you look closely you'll see that the folding stock

is far out in front of the blaster.

 

the end cap and total barrel length with barrel tip

would add several MM to each side of the Total length.

Edited April 25, 2010 by TK Bondservnt 2392

[dashrazor]

dashrazor which blueprints do you speak of?

 

there are several sources for blueprints. I'm looking for an accurate set.

 

I'm going to purchase a machinist's version.

 

I've seen plans produced by a guy that did an airsoft conversion and

his plans are wrong.

 

good luck on your blaster mod quebectrooper!

 

i have got those airsoft ones and there very close, more detailed than the bbc ones (the only thing i notice that was off was the original barrel diameter was not exactly1.5 inches) but the origonal manual Here tells the accurate length

 

 

if you find some better ones i want them 2 lol:D

Edited April 25, 2010 by dashrazor

[TK bondservnt[501st]]

those measurements are also suggestive of the accuracy of the sterling cast I have. being only 3/8 inches off in total length makes me

think that the folding stock is seated a little bit forwards on my copy.

 

I'd go with the understanding that we're not just talking about the barrel's length here... but the total length with folding stock folded.

the folding stock extends beyond the barrel's length, keep in mind.

 

and I"d never use 1.5 for a diameter.

 

schedule 40 PVC1120 450psi @73F ASTM D1785 NSF code JM90 ST is the most accurate diameter

I've seen for a pvc pipe compared to my resin E-11.

Edited April 25, 2010 by TK Bondservnt 2392