Fancy

I'm 6'1" so I stretching the limits of fit. The ab plate where if curves around the right side is definitely a sharper angle than left and sticks out a little. I'm going to try trimming the return edges and adjust the strapping before I goto heat forming. It's really close to fitting right until I move then the chest pops up on the right side and the return edges catch each other keeping the chest from sliding over. Oh and I have a Blaster Factory E11 on order. Hence not in the picture. Thanks for the input folks.

Hey everyone! After months of lurking and data mining these wonderful forums I ordered a commission build from Authentic Props. Turn around time was a surprisingly quick 5 and half weeks. I was pretty sure it would still need some tweaks and adjustments to fit "just right" but was pleasantly surprised how well everything fit. What I've identified to adjust. Trim return edge and heat form the ab plate to fit a little closer. this should allow the chest plate to overlap. Shorten shoulder to bicep straps, to get proper overlapping. Trim return edges/tops of thighs to be able to bring them up a little further. I think that should cover my needs for basic approval. I also plan to redo the sniper knee attachment to get it perfect. Replace hovi tips and helmet seal with lvl 2/3 appropriate versions. I'm pretty sure that'll cover basic and EI levels. And most importantly my preference. The linked pic is directly out of the box, and my very 1st time suiting up. obviously all suggestions are welcome. https://flic.kr/p/2oWZLcd

I've very recently looked at all the blasters on the reference page that was shared here. What I've settled on is a Blaster Factory and a painting a Rubies. One very detailed for eventual EI and Centurion. And one very lightweight and almost disposable. For trooping? I'll have either available depending on the setting/type of troop.

Well I've changed course slightly. I've decided go with an Authentic Props kit. Just put in my order. Soft parts ordered as well. Just need a blaster.

Thank you, I may very well do that. I'm still in the middle of my move but intend to start spotting ASAP. I figure that's a good way to meet folks and maybe learn along the way.

I'm still undecided on a full build vs commissioning and then just tweaking to make sure it fits perfectly. I'm not in a rush either way.

Hello everyone. I'm finally jumping in after decades of "being too busy". I have my heart set on an RS prop masters kit. Just waiting for their next run. Very much looking forward to getting it and putting it together. I'll be happily spotting until I can troop myself. Thanks for having me.

Well I'm on my to add one more TK.