Cupcake

Christine Harris TK-61102 EIB Letter TKSpartan Here you are, Christine!- https://www.whitearmor.net/eib/certificates/61102-eib.png

Christine Harris TK-61102 Centurion Letter TKSpartan Way to go, trooper!! https://www.whitearmor.net/eib/certificates/61102-centurion.png

Thank you!!! And a big thank you to the troopers who took the time to comment and offer support.

Hello! I've completed the changes you requested. Teeth: I used paint remover and pushed back the paint on the teeth. Ear Screws: Replaced with flat slot-head screws. I needed to lift the glued s trim to change the screws. When I get the ok on them I'll glue the trim back down. Mic tips: Painted inside of mic tips entirely white. Ab button plate: Removed, trimmed and re-glued rectangular ab button plate. Forearm opening: Trimmed off remaining return edge from hand opening on both forearms. Belt: Starched and Ironed belt. Re-took photos with belt on tighter. As you mentioned, I think it was just on a bit loose before. Knee: Removed and re-glued sniper plate higher; now it follows the ridge line.

Thank you for the feedback and advice. I've looked over the list of changes required and they all seem doable. I'm very busy with work right now so it may take a couple of weeks. Stay tuned!

I added the pictures from the correct checklist and an action photo.

Oh. That also was not clear in what I was reading. I think the crl threw me off. Good news, I do have a blaster, the same one I applied for EIB with. I will add photos later today.

I am applying without the blaster.

I think it should be all there now!

Ok! Not a problem. Sorry about that. There's a couple checklists floating around this topic so I missed that specific one. I'll get to it asap. Sorry again for the delay.

I found that tutorial from another post you replied to. Thank you!

Name: Christine Harris Armour: Anovos Helmet: Anovos Blaster: Resin Blaster EIB thread: https://www.whitearmor.net/forum/topic/36821-tk-61102-requesting-anh-stunt-eib-status-anovos570/ Height: 5’10” Boots: TKboots Canvas belt: Custom Hand Plates: Silicon Electronics: N/A Neck Seal: Custom Holster: Anovos Hello, thank you for taking the time to consider my TK build for Centurion. I built this kit to Centurion level when I originally built it in 2016. Due to health issues and then the pandemic my application was delayed….I am FINALLY doing it!! I have read over the requirements and found a couple changes that have been added since 2016, which I went ahead and updated. -painted my mic tips outer edge white -glued abs backing behind the lower thigh ridges and will be adding slurry next to cover. Please note: My bucket S trim is glued so it can't be lifted easily for a photo. I posted a pic of the obvious extra ridge the S trim has but if you need a photo of the inside of the trim, let me know, I'll need to peel the glue. (above) my driveway is sloped a bit that's why I may look a tad crocked in the butt.

When someone gets to this, I'd just like all the attachments I added today (sept14th) removed. Thank you!!

Hello, I attached photos to my Centurion request and blew over my size attachment allowance. Now I can't delete or edit them. Help please!

Thank you!